The push button features an easy click-on mechanism for wall-mounted bus wiring controls.
The following articles are required to install a single push button:
-
a flush-mounting box (A)
-
a simple wall-mounted printed circuit board (550-14110 or 550-141x6) or a multiple wall-mounted printed circuit board (550-14106 or 550-140xx) (B)
-
a push button (C)
-
faceplate (D)
-
If you install a multiple wall-mounted circuit board, you also need a connection unit (550-14090).
-
You can use a single flush-mounting box to install multiple push buttons (up to three horizontally or vertically) in one location.
-
The wall-mounted printed circuit boards are available with claw and screw fixing.
Mount the push button by pressing the connection unit onto a Niko Home Control wall-mounted printed circuit board until it clicks into place.
It will automatically connect to the Niko Home Control bus through two contact springs.
Mind the orientation of the push button: the spring contacts should be located at the bottom.
In closing, mount the faceplate (D) on the printed circuit board via the SnapFit mechanism.
|
|
A. Single flush-mounting box (not a Niko product) B. Single wall-mounted printed circuit board C. Push-button D. Faceplace |
|
Installation diagram for single wall-mounted printed circuit board |
|
