ChannelDescription
The MOTIV Wireless LED dimmer is equipped with a dimmer output for controlling lighting loads. An additional LED compensator (310-05001) could be needed when using the LED dimmer in a 2-wire circuit when lamp flicker is seen, or to remove afterglow with lamps or reduce switching delays between led drivers in a light circuit.
It can be used as a replacement for a conventional wall dimmer and features an extension input for local control using an external push button.
The module can be installed behind a blind plate or behind a push button in the finish of your choice. When installed behind a push button, a wall-mounting box with a minimum installation depth of 50 mm is required.
During the addressing phase, the output will toggle as a confirmation that addressing is completed successfully.
Wiring scheme
Image TBA
LED and push-button behaviour
Add drawing here with position of LED and push button
LED behaviour
|
LED behaviour |
Description |
|---|---|
|
On |
Load switch on |
|
Off |
Load switch off or power off |
Reset LED button behaviour
|
Network status |
LED behaviour |
|---|---|
|
The network is close |
|
|
The network is open |
LED stays RED for 3s and turns off when pairing is successful |
Push-button behaviour
|
Button |
Button press |
Channel |
|---|---|---|
|
K1/Reset |
Short press |
Channel |
|
times. |
Factory reset |
|
|
K2/Manual |
Short press |
Channel 2 load switch on/off |
|
S1 |
Short press |
Turn load on |
|
Long press |
Dim up until release |
|
|
S2 |
Short press |
Turn load off |
|
Long press |
Dim down until release |